How to Reset a Bryant Furnace Unit: A Step-by-Step Guide
When your Bryant furnace in your Colorado, home isn’t heating properly or seems to be acting up, a reset might be all it needs to get back on track.
However, before you dive into resetting your furnace, it’s essential to understand that there could be various underlying issues. If the problem persists after a reset, it might be time to call a professional like an authorized dealer from Bryant Colorado.
When Should I Reset My Bryant Furnace?
Before you start, it’s helpful to understand why you might need to reset your furnace. Common reasons include power surges or outages, thermostat issues, or overheating that triggers a safety shut-off.
Whether you are dealing with an error code or your furnace just isn’t firing up as usual, following the simple instructions in the guide below could save you both time and money on an emergency repair.
How to Reset a Bryant Furnace
Here is a step-by-step guide to resetting your Bryant furnace.
Turn Off the Power
Before you start any work on your furnace, ensure it’s completely powered down. This step is crucial for your safety. Either use the furnace power switch or turn off the furnace at the circuit breaker panel.
Then, allow the furnace to remain off for at least 5 to 10 minutes to let components cool down, which can help reset the furnace’s electronic control board.
Check the Thermostat
While waiting, verify that the thermostat in your Colorado home is set to both the heating mode and the desired temperature. The furnace must be set to a temperature higher than the current room temperature to start. If necessary, replace the thermostat batteries.
Reset the Furnace
Many Bryant furnaces have a reset button located on the furnace’s control board. After opening the access panel, look for a red or yellow button on the control board. Press the reset button firmly.
If there is no visible reset button, your furnace might not have one or it is located somewhere else. You may need to check the manufacturer’s reset procedures for where it is located or other reset options.
Once the reset is complete, close the furnace access panel securely. Ensure no tools or objects are left inside the furnace area.
Turn the Furnace Back On
With everything back in place, turn the furnace on and adjust the thermostat to the desired temperature for your Colorado home. Listen for the furnace to kick on and start heating. It might take a few minutes for the furnace to start up and for warm air to begin circulating.
Troubleshooting
If your furnace doesn’t start or the issue persists after resetting, consider the following:
- Check for Error Codes: Some Bryant furnaces display error codes on the thermostat or control panel. Refer to the furnace’s manual to interpret these codes.
- Inspect the Air Filter: A clogged air filter can cause furnace issues. Replace or clean the filter if necessary.
- Ensure Proper Gas Supply: If you have a gas furnace, ensure the gas supply is on and there are no issues with the gas line.
When to Call an HVAC Professional
If you’ve tried resetting the furnace and addressing common issues but still experience problems, it’s best to contact a professional HVAC technician within the Bryant Colorado network.
Persistent issues could indicate more complex problems, such as electrical or mechanical failures, issues with the furnace’s igniter or burner, or problems with the furnace’s internal components. Regular maintenance and timely repairs can also help prevent future issues and keep your furnace running smoothly all year round.
Resetting a Bryant furnace is often a straightforward process, but it’s crucial to handle the task with care. By following these steps, you can potentially resolve minor issues and get your furnace back to working efficiently.
Always prioritize safety, and don’t hesitate to seek professional help from a Bryant Colorado authorized dealer. Use our Find a Dealer page to locate an HVAC technician near you in the greater Colorado metropolitan area.